Không có sản phẩm trong giỏ hàng!
![Robot Antenna Robot Antenna](https://static.cytron.io/image/tutorial/robot-antenna/photo_2018-08-02_18-21-45.jpg)
Robot Antenna
INTRODUCTION
I have this paper robot and I want it to look fancy by adding an LED on his head. Hihi. So I decided to make this antenna and adding a sound to it using Raspberry Pi.
VIDEO
This is the video for this project.
HARDWARE PREPARATION
This tutorial use :
You can make the hardware connection based on the diagram and table below.
Connection | |
---|---|
Speaker | Raspberry Pi : Audio Jack |
Red LED (+) | Raspberry Pi : GPIO 17 |
Red LED (-) | Raspberry Pi: GND with Resistor |
![](https://static.cytron.io/image/tutorial/robot-antenna/finished-circuit.png)
![](https://static.cytron.io/image/tutorial/robot-antenna/led-wired.png)
SOFTWARE
This project is using Scratch 2.0 with GPIO support.
![](https://static.cytron.io/image/tutorial/robot-antenna/Scratch-2.0.png)
SAMPLE CODE
This is the sample code used for this tutorial. Try it!
![](https://static.cytron.io/image/tutorial/robot-antenna/Coding.png)
THE IRON MAN
This is the image for the Iron Man paper craft. Kindly download it here.
REFERENCE :
- I took an example from this page. You can always check this page as it provides many tutorial starting from beginner to advance.
Thank you
Thank you for reading this tutorial and we hope it helps your project development. If you have any technical inquiry, please post at Cytron Technical Forum.